For a dual 120MM one it's about R30.inf3ct10n wrote:hmm, what does a grill like that cost to make? coz im in need of one of those for my Triple Airplex Evo
Haha no, the laser place will kick my bottomSkidd wrote:LOL Wik I think you should go into some production there
AC Wik1d
True, but I just wanted to show you that it isn't UV Reactive PlexiSamaya wrote:Ja the Blue looks better but only cause its brighter... lol. Anyway, that rad grill is going to look awesome. Can't wait to see the the end product of that!
Yeah, it does look great, but it doesn't fit perfectly, but I do have a solutionDAE_JA_VOO wrote:We were at the laser place today. That grille DOES look awesome, but it's a bit too big
Wik will update for you guys
It's not that easy, you have to work with 0.XX millimeters. Not a millimeters.DoOb wrote:Measure TWICE Cut onceDAE_JA_VOO wrote: That grille DOES look awesome, but it's a bit too big
Yeah, but I don't feel like itDAE_JA_VOO wrote:Hey he can just remake it, no big deal
Anyways
Updates FTW. Unless they suck, like this one.
So me and Ettienne went to the Laser Place today, to test cut the mobo panel and radgrill.
And here's what was made
The Motherboard Panel
I have to make the text wider, there's barely a hole in there
The snazzy radgrill
On my AC Ryan Radgrill, now here's the problem, as the thing became wider the plexi moved more out of place from the original, so at the last few strikethroughs you can see that the plexi isn't exactly underneath the rad grill. But that's no problem, I'm just going to cut a black radgrill, and use that in the place of the AC Ryan one.
Then my motherboard
Then the plexi ontop of the board.
Now there's a LOT of measurement problems. I felt so crap after I test fitted it, it sucked guys you have got no idea.
The PCI slot is too low
The top corner thing is too high
The PCI and GFX cards have a little PCB piece at the left side of the board and that pushed into the plexi
The northbridge block holes were too small
The ATX and 8 Pin wasn't positioned properly
The SATA Port hole has to move left
I'm going to have to lower the plexi even more, so the following changes has to be added:
Bigger holes for the ramslots must be made so that both slots are open
The CPU block hole has to change from a rounded square to an oval
I have to make holes for the high capacitors and mosfet coolers in the top right corner of the board.
So yeah, that completely sucked guys, but yeah, I have to make this panel, somehow
Cheers guys, enjoy your evenings.