a New Case Mod Project I have started!
Hi Guys,
Thanx for the feedback - I got mine directly from Rectron.....Carly's pricing is real good though! Very good support too....
Been doing a little shopping at East Coast Instruments in Durban this afternoon, and foraged around for proper fittings to mount my Swissflow inline -
2nd from left is std 3/8" to 1/2" brass barb, on the left is one after subjected to some dremel and sanding acting - slightly shorter, and neater in appearance.
Silver barrel is 316 stainless 3/8" socket.....and obviously part on right is the Swissflow Ind Flowmeter...
after fitting it will look like .......
And a final close-up shot - note I still have to put threadlocker on, to prevent leaks. Will do final fit on the weekend. Things moving along slowly, but surely.
Thanx for the feedback - I got mine directly from Rectron.....Carly's pricing is real good though! Very good support too....
Been doing a little shopping at East Coast Instruments in Durban this afternoon, and foraged around for proper fittings to mount my Swissflow inline -
2nd from left is std 3/8" to 1/2" brass barb, on the left is one after subjected to some dremel and sanding acting - slightly shorter, and neater in appearance.
Silver barrel is 316 stainless 3/8" socket.....and obviously part on right is the Swissflow Ind Flowmeter...
after fitting it will look like .......
And a final close-up shot - note I still have to put threadlocker on, to prevent leaks. Will do final fit on the weekend. Things moving along slowly, but surely.
-
- Registered User
- Posts: 12310
- Joined: 28 Nov 2005, 02:00
- Location: That other place
- Contact: